Centrifugal Barrel Finishing Machine Supplier Share How To Control The Noise Of The Polisher

Centrifugal Barrel Finishing Machine Supplier Share How To Control The Noise Of The Polisher

Owner: machineunique

Group members: 1

Description:

According to the reason of the noise of the polishing machine, it can be known that the noise is caused by the unbalanced force of the grinding head when the brick is ground, and the vibration is the real factor of the noise. The vibrations that occur during polishing are typical dynamic instability scenarios. Then, the Centrifugal Barrel Finishing Machine supplier will share how to control the noise of the polishing machine?

Through the vibration analysis of the polishing machine grinding head, it was found that the noise affecting the grinding head is the grinding width and the polishing machine speed. The appropriate grinding width and speed can be selected to prevent resonance and effectively control the noise of the polishing machine.

Improving the grinding width and the speed of the grinding head can make the noise disappear. Only need to pay more attention and inspection of the polishing machine, find the correct factors, improve the bad mechanism can achieve the desired effect.

The noise of the polishing machine disappears, and the operator can perform polishing work in a quiet environment, which greatly improves the operation effect and power. I hope that everyone facing this problem will work hard to improve and build a good job. surroundings.

 

information about centrifugal barrel finishing machine : https://www.zhongyun-machine.com/product/